PM486FP
1.91″ (48.6mm) Diameter
24V DC
- 150% more torque then PM486FS
- Transport product up to 400 lbs.
- Incline conveyor/belt applications
- Continuous or intermittent duty
- DC brushless motor provides long life and is protected from overheating
- 7/16″ hex (threaded) shaft
- Dynamic Brake
- ABEC 1 Bearings, zinc plated carbon steel tube
- Utilizes Driver cards CB-016S7, CBM-105 , Hybrid Driver Card HB-510, 2 Zone Hybrid Driver Card HBM-604, or 2 Zone Controller Card IB-E03
- Standard Threaded Hex Shaft (JT); Also available with Yoke Shaft (JR)
- Standard Hex Shaft requires two P-0B1 (Hex flat up) or P-0C1 (Hex point up mounting brackets)
- Yoke Shaft (JR) requires two MBB-071 (Hex flat up) or MBB-081 (Hex point up) mounting brackets
- Available with Straight or Grooved Tube (Standard Groove location 50/32)
- Available Options: Lagging, Low Temp, Brake, Waterproof, PV or GV belt pulley end cap or Sprockets (40A18 only)
Specification Document
![]() |
PM486FP Product Sheet |
Installation Instructions
![]() |
pm486fp_installation_instructions |
Note: Mounting nuts for standard threaded shaft to be torqued to 22.1 lb-ft. +/- 10%.
Extension Cables
![]() |
Molded Extension Cables Product Sheet |
Technical Support Documents