CB-016S7 (NPN) OR CB-016P7 (PNP)

Models Applicable

PM486FS, PM486FE, PM486FP, PM570FE, PM605FE, PM635FS

9 pin connector

CAD Drawing Download (.DWG)

CB-016S7

• Adjustable acceleration and deceleration time (0 to 2.5s)
• Stable speed operation
• Manual or automatic recovery of the thermal overload device
• One (1) DIP switch combined with one (1) rotary switch to select up to 20 different fixed speeds
• Forcibly stops the motor if motor lock or thermal overload error lasts for 4 seconds or more.
• Three (3) LEDs (green, red, & orange) to identify the type of error and number of error occurrences
• Error occurrence indication
• Displayed only when error condition is present
• Pulse signal output to indicate motor revolution
• Lead free design; RoHS compliant
• Low Voltage Protection reacts when
• Sustained low voltage (less than 15V DC) for at least 1 second
• Fluctuating voltage dropping below 15V DC, 5 times within 0.5 second
• Delayed Start-up Over-current response
• 1 second delay after RUN signal is applied, before over-current indication is active
• Eliminates false over-current indication during motor start
• External Direction control
• When external DIR signal is changed while motor is running, the motor stops for 0.5 second, then runs again in opposite direction

Enhancements over CB-016S4

• Increased Torque / More efficient components / Improved protection against generated voltage due to Power Moller overspeeding.

• Snap-on cover makes NPN/PNP switching easier (better visibility) / Card does not have to be removed from conveyor frame to remove cover.

Specifications:

Electrical	• 24V DC ±10% input • Battery • Power Supply: fullwave rectified with smoothed current and < 10% Ripple • Power ON delay < 1s • 4A locking current • Input signal level for activation • 0V (3V or less) for NPN • 24V (18V or greater) for PNP • Output (Error and Motor Pulse) signals • Open collector 24V, 25mA or less • NPN • PNP (selectable for Error only) • Brake model only • 0.2s delay between stop signal and mechanical brake reaction • 0.2A brake current @24V (< 0.1s) • Brake coil is active (disengaging brake) while motor is running
Brake	• Dynamic (Electric-Both models) • Mechanical (CB-016BS7 only)
Protection	• Thermal protection reaction • 85° C (185° F) on the PCB • 105° C (221° F) in the motor • Built-in 5A fuse for power supply protection • Built-in diode for incorrect wiring protection
Applicable Environment	• Temperature 0~40° C (32~104° F) • < 90% Relative Humidity (No condensation) • No corrosive gas • Vibration < 0.5G
Power Source	• 24VDC Battery or 24VDC Power Supply• Battery or fullwave rectified with smoothed current < 10% Ripple