Power Moller Options
Please refer to your roller’s individual specification sheet to view option availability.
Rubber Laggings (NR, UR, NB, CR)
Prevents light loads from slipping and protects the surface of loads during transfer. Rubber is molded (vulcanized) onto the tube to assure permanent adhesion.
NR: Natural Rubber
UR: Urethane Rubber
NB: Nitrile Rubber
CR: Neoprene Rubber
Built-in Brake (BR)
Eliminate load inertia and enable precise stopping. Electromagnetic brake is engaged by spring force when power to the motor is interrupted. Minimum tube length is 250mm (10″) and -One-touch- mechanism is included with tube lengths of 300mm (12″) or more. Maximum Continuous energized time is 30 minutes with a 70% duty cycle.
Waterproof (WA)
Designed for outdoor lines or lines subject to water spray (washdown).
Output and attaching shafts, end caps and tubes are made of stainless steel to resist corrosion. Waterproof specification IP-65, IEC 529.
- Direct Water Spray to Shafts in Washdown Application may reduce life power of Moller.
- Waterproof Option may affect speed and torque.
- Contact Itoh Denki for speeds available.
Drip Proof (DR)
Used on conveyor lines that are located in areas with high moisture levels.
Attaching shaft and shaft caps are made of stainless steel to resist corrosion. Drip Proof specification IP-55, IEC 529.
Low Temperature (LT)
Low temperature grease, spring-loaded shaft, air removal inside tube, rust-proof internal circuitry, reinforced gearbox and low temperature mechanical operation.
Available on the PM486FE, PM486FP, PM570FE, PM605FE, and PM486XP rollers. Also available on the CB-016S7 and HB-510N cards.
Dust Proof (DU)
Used in dusty or powdery environments. Rubber seals protect the POWER MOLLER® bearings from contamination.
Clean Room
Designed for the handling line that requires a high degree of cleanliness, such as in the electronics, food and pharmaceuticals industries etc. Includes the features incorporated in the drip proof option as well as standard leadwires and stainless steel tube, attaching and output shafts.
C2 – Class 100 Clean Room
C3 – Class 1000 Clean Room
Belt Pulley and Grooves
POWER MOLLER® and corresponding idler rollers are available with a special end cap or grooves to accommodate small V-belts or round belts. The POWER MOLLER® can be linked to idler rollers on light load/small size applications where consecutive -live- rollers are required. Minimum tube length is 250mm (10″). One Touch attaching shaft is standard for all tube lengths.
