HBM604BP

2 Zone Hybrid Driver Card – HBM-604

Models Applicable

PM486FS, PM486FE, PM486FP, PM570FE, PM570FP, PM605FE, PM635FS

(10-pin motor connector)

• Controls up to 2 Power Mollers (Brake and Non-Brake models)

• 2 available sensor connections that power and receive the output from sensor

• Built-in thermal protection for both driver card and Power Mollers

• Dynamic brake control

• Stable speed function to ensure articles of different weights travel at the same rate

• Variable speed control by rotary switch

• Direction control by onboard DIP switch or external signal input

• Logic for general Zero Pressure Accumulation(ZPA) control is built-in

• Flexible Zone Reconfiguration to handle long articles which simultaneously block     multiple sensors

• Easy connection between adjacent HBM-604’s with communication cable to simplify wiring

HBM-604 Diagram

Operation

  • Cycle: 1s ON; 1s OFF
  • Continuous or Intermittent duty
  • Do Not Exceed 150% of no-Load Speed

Environment

  • Ambient Temperature: 32 to 104℉ (0 to 40℃)
  • <90% Relative Humidity
  • (No condensation)
  • No Corrosive Gases
  • Vibration: < 0.5G

 

Protection

  • Thermal overload 199℉ on PCB
  • Thermal overload 221℉ in motor
  • Two(2) 7A fuses for each motor
  • Protection from incorrect wiring (reverse polarity)

Connectors for power and control are:

Power: WAGO #734-102 (Included)

Sensor: WAGO # 733-103 (Included)

Optional External Control: WAGO #733-106 (Not Included)

* Non brake model rollers must use 10-pin motor connector

TECHNICAL SUPPORT INFORMATION