PM486LDforwebsite

Picture1

PM486LE/LD

1.91″ (48.6mm) Diameter

24V DC

  • 1.9″ Diameter
  • 7/16″ plain hex shaft (standard)
  • High speed capability up to 260.2 FPM
  • Operates at half the amperage of traditional MDRs
  • Shorter minimum tube lengths; minimum length with dual groove O-ring optionis is only 11.61”
  • Easy frame insertion with 3 pin connector thru 7/16” hole
  • Motor commutation is controlled by the new HBL-606 driver card
  • Choice of either plastic (LE) or zinc (LD) end caps
  • Roller requires one MBB-071 (Hex flat up) or MBB-081 (Hex point up) mounting bracket.
  • Available with optional VG pulley
  • Available as straight tube or grooved tube. Grooves standard at 50/32mm

 

PM486

Operation

  • Cycle: 1s ON; 1s OFF
  • Continuous or Intermittent duty
  • Do Not Exceed 150% of No-Load Speed

 

Protection

  • Thermal overload 167ºF(75ºC) in the motor when used with an Itoh Denki controller

 

Environment

  • Ambient Temperature: 32~104º F (0~40ºC)
  • Relative Humidity: < 90% (No condensation)
  • Vibration < 0.5G
  • No Corrosive Gases

 

Technical Support Documents

AutoCAD File